Effect of Cutting Parameter on Material Removal Rate and Surface Roughness in Deep Drilling Process

Authors

  • Mostafa A. Abdullah Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq
  • Ahmed B. Abdulwahhab Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq
  • Atheer R Mohammed Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq

DOI:

https://doi.org/10.26389/AJSRP.M23416

Keywords:

Taguchi, ANOVA, surface roughness, MRR, Tool diameter, Material Removal Rate

Abstract

In the curents study aimed to assess the effects of cutting conditions (spindle speed, feed rate, tool diameter) parameters as input impact on material removal rate (MRR) and surface roughness (Ra) as output of steel (AISI 1015).
A number of drilling experiments were conducted using the L9 orthogonal array on conventional drilling machine with use feed rate (0.038,0.076,0.203) mm/rev and spindle speed (132,550,930) rpm and tool diameter (11,15,20) mm HSS twist drills under dry cutting conditions.
Analysis of variance (ANOVA) was employed to determine the most significant control factors affecting on surface roughness and MRR.
The result shown the tool diameter the important factor effect with (64.08%) and (76.12%) on MRR and surface roughness respectively.

Author Biographies

  • Mostafa A. Abdullah, Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq

    Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq

  • Ahmed B. Abdulwahhab, Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq

    Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq

  • Atheer R Mohammed, Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq

    Department of Production Engineering and Metallurgy - University of Technology - Baghdad - Iraq

References

Downloads

Published

2016-06-30

Issue

Vol. 2 No. 5 (2016)

Section

Content

License

Copyright (c) 2016 المجلة العربية للعلوم ونشر الأبحاث

How to Cite

Abdullah, M. A., Abdulwahhab, A. B., & Mohammed, A. R. (2016). Effect of Cutting Parameter on Material Removal Rate and Surface Roughness in Deep Drilling Process. Arab Journal for Sciences and Research Publishing, 2(5), 285-274. https://doi.org/10.26389/AJSRP.M23416